With the continuous development of science and technology, daylighting panels are more and more widely used in real society. The daylighting board is to reserve a hole on the roof panel, make a well wall around the hole, and install a daylighting skylight with a flat light-transmitting material on it.
Daylighting panels are commonly found on the roof of houses, but there are certain requirements for the installation of any product. What are the requirements for the installation of daylighting panels? What are the connection methods for it?
When the lighting board and the steel plate are overlapped, the lighting board should be directly covered on the color steel plate, and the overlapping position needs to be sealed with waterproof tape.
Different daylighting panels are also fixed differently. For example, corrugated daylighting panels need to be connected and fixed with the bracket of the lighting panel, or self-tapping screws, and then the surface can be sealed. The position of the board is placed in the mid-span. If you are connecting the lighting board with self-tapping screws, remember to use the cover plate. Because the lighting board is greatly affected by cold and heat, it will be deformed, and it will be directly cut by self-tapping screws. Therefore, when tapping the lighting board with self-tapping screws, the holes should be opened larger.
When installing the daylighting board, try to avoid breakage, or damage to it by heavy objects and tools. When it's time to master people, people can only step on the top of the purlins. The lighting board cannot be punched, only drilled.
Therefore, while installing the daylighting panel, it is also necessary to consider the stretchability of the daylighting panel itself. When the lighting board is within 12m, it is basically not necessary to do any lap joints. If it exceeds 12m, lap joints must be performed. Normally, the length of the lap joint is between 200-400mm, and the length of the lap joint is between 200-400mm. The position of the joint needs to be coated with sealant. If it is a horizontal lap joint, no edge treatment is required, while the longitudinal lap joint is determined according to the board type.
The above is the relevant content of the lighting board, I hope it will be helpful to everyone.
Tangshan Runfeng Composite Material Co., Ltd https://www.frpexpert.com/. welcomes your visit!